Thursday 25 April 2013

Building a sliding mount for my in car radio


Now that the weather is getting better, I am looking to fit my mobile radio into my car. I don’t want it to be a permanent fixture as it could be stolen if left in unattended. I have decided on where I want to fit the radio and have devised a bracket design that will allow me to slid the radio in and out. I’ll still have to connect the power and antenna but this will only take a few seconds. I am going to make the brackets out of various pieces of brass soldered together. I have cut out the bits I’ll need and a photograph of these is shown below. My next job is to fabricate the channels so that they are blocked at one end. These will then be soldered onto the larger sheet of brass which I’ll attach to the radio mount. The small sheet of brass will be mounted in the car where the radio bracket will slid over it. When I get some spare time to do the drilling and soldering I’ll post the next set of pictures.

No comments:

Post a Comment